Simplify3D

[Alibert]

The scarring depends on the type of plastic, PETG is really bad, PLA a bit better and ABS the best of all.
In the support tab you can specify how many layers to leave free between support and part. Normally it is 1, but you can set it to 2 and see how that works.

[lycan]

The scarring depends on the type of plastic, PETG is really bad, PLA a bit better and ABS the best of all.
In the support tab you can specify how many layers to leave free between support and part. Normally it is 1, but you can set it to 2 and see how that works.

Hi Alibert,

Thanks for the reply - I am printing in ABS at the moment and the rest of the unsupported prints are beyond perfect ( really love this software ). I will try increasing the spacing as you suggested and let you know the outcome.

Cheers