Close



Results 1 to 4 of 4
  1. #1

    Can't calibrate nozzles for dual extrusion

    I'm using Makerbot 2.4.1.24 on my replicator clone with factory firmware. I have tried multiple times to calibrate the nozzles using the onboard calibration from the lcd and configuring onboard preferences from makerbot software. No matter how much I adjust it, it doesn't seem to make a difference. Any ideas?


    IMG_20161013_212824887.jpg

  2. #2
    Are you using an ooze shield?
    What is the brand of that clone printer? It might have a slightly different setup.
    Editor in Chief
    Bitsonline

    Tips Appreciated But Not Expected
    BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
    DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq

  3. #3
    Not sure what ooze shield is. And this is a CTC printer. Hence the reason I posted in the CTC forum.

  4. #4
    The MakerBot software has a ooze shield option. I will have to check it tomorrow when I'm on my laptop.
    It creates a place for the nozzles to wipe off kind of to keep colors from running.
    Here is a pic of what one looks like on the frog I printed.
    Of note I just was not sure the model of your CTC printer.
    [IMG][/IMG]
    Editor in Chief
    Bitsonline

    Tips Appreciated But Not Expected
    BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
    DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •