Results 3,511 to 3,520 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
10-08-2016, 06:03 AM #3511
- Join Date
- Sep 2016
- Posts
- 2
I've checked the PS connections several times. will try to tighten the rest of connections.
-
10-08-2016, 07:42 AM #3512
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Pac-Man ghosts in clear Makergeeks PLA. Click the link to see. I don't know another way to add a video!
http://vid58.photobucket.com/albums/...ps74lljos2.mp4
-
10-08-2016, 12:58 PM #3513
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 01:05 PM #3514
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
Fluctuation of 2 degrees in temp reading is normal. Blacking out, not so much. Pay particular attention to the power supply cabling and spade lug crimping etc. Could be a bad connection from the PS to the main board. Also look out, the folks assembling these units DO NOT always follow the RED=+, BLACK=- conventions.
-
10-08-2016, 01:06 PM #3515
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 02:15 PM #3516
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 02:21 PM #3517
- Join Date
- Sep 2016
- Posts
- 80
I didn't do rafts, just had blue tape. Scotch, not Blue Hawk.
IIRC, as I said on most of my prints, the skirt is crap and mostly doesn't stick (and with the little feet there's a bunch of small skirts) but the main printing is fine.
Here's the factory file I saved at the time: https://www.dropbox.com/s/ulwiqk7u8o...t.factory?dl=0
-
10-08-2016, 03:07 PM #3518
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
I have found using minimal rafts is the key. I am now able to do 6 at 50% at a time. Fills the bed but it's the size in my video. With the rafts the feet stick great and you can go at full speed.
-
10-08-2016, 04:29 PM #3519
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-08-2016, 04:50 PM #3520
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Sending a set to my sister and who knows who may buy some sets. The light kit comes with five lights. They take forever to print!
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help