Results 1 to 10 of 12
Threaded View
-
03-19-2014, 11:29 PM #3
HI Rob,
I liked the idea of adding the switches in to control the fans, I have installed one at the hot end to help with PLA printing.
I got some bad news though, the printer board that I am using does not support a heated bed.
- Does any one have suggestions on a new printer board that is more along the lines of a plug and play, I have no electronics experience and would prob break it.
- Or are there any suggestion to use a heat bed on another controller or another setup as I already have the head bed?
I have also discovered that while replacing my thermistors that if i added 2 them together I get a more consistent temperature reading.
I have also been using a ABS gloop that is made of asatone and waste abs, it melts down and turns a little like wood glue, if you pour some on glass and smear an even layer it helps stop warping.
I will upload some picks of my machine and some of the prints as well soon as I can.
thanks
Pom
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help