Results 1 to 7 of 7
Thread: ABL Servo probe issues
Threaded View
-
10-06-2016, 09:18 PM #4
Can you post your Configuration.h file? In the past, servo #2 was used for the Z probe. But if there was only 1 servo in the system that didn't make sense. Now the default servo is #0. You should get very repeatable action when you do a:
* M280 - Set servo position absolute. P: servo index, S: angle or microseconds
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion