Quote Originally Posted by wirlybird View Post
I need to print a piece that is 170 by 170. It will not be very tall so that is not an issue. Has anyone tried a slightly larger piece of glass or other method to extend the bed for special circumstances? this would only be for occasional use!
I am thinking for limited use I may go to the hardware store and just get a piece cut. It will be printed in PLA so temp isn't to bad.
I'm not sure if there is enough travel for that, it would be very close to tripping the Y switch or hitting the front. 160 might be do able. You might have to split and glue that one.