Results 3,461 to 3,470 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
10-03-2016, 01:24 PM #3461
-
10-03-2016, 03:59 PM #3462
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
https://www.amazon.com/Mold-High-Res.../dp/B00IZNNIU8
Similar to this one?
-
10-03-2016, 04:23 PM #3463
Ya that is it, some mold release spray is needed also.
-
10-03-2016, 08:03 PM #3464
- Join Date
- Sep 2016
- Posts
- 80
So, I was running low on blue tape and while at Lowe's I got some more. I ended up getting Blue Hawk brand, mostly because that was actually available in the widest rolls.
Bad mistake. Stuff barely sticks. I'd recommend against it.
-
10-03-2016, 09:33 PM #3465Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
10-03-2016, 11:14 PM #3466
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-04-2016, 12:04 AM #3467
-
10-04-2016, 12:12 AM #3468
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
10-04-2016, 05:07 AM #3469
- Join Date
- Mar 2016
- Posts
- 29
All installed and up and running it only took me 7 ours but that was with doing other stuff as well.
Just a little bit of fine tuning to be done but that will have to wait until tomorrow.
I wanted to take photo's so i could show how the install went but i got exited and didn't take any.
Will post pictures of the finished install tomorrow.
-
10-04-2016, 06:26 PM #3470
- Join Date
- May 2016
- Posts
- 55
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help