Anyone using Flexion extruders on a FFCP-2016?

[wirlybird]

I am getting ready to move my Flexion extruders to one of my FFCP's and was wondering if anyone is running them.

Thoughts? Opinions? Advice!!

[Todd-67]

Bump.... same question. I have been looking at them a lot lately.

[Talon 3D]

I have not yet. They do look nice. Weird issue though with them saying they don't work well with NijaFlex yet are supposed to be made to work with Flexible materials.

[Warp Norman]

Talon, The original flexion is made to work with ninjaflex. The flexion HT may require tweaking but the barrels change out very easy if you need to swap back. The flexion HT comes with both barrels for the dual extruder set up.

[Talon 3D]

That is great to know.
I have been looking more and more into some of the flexible materials. I will look into possibly getting a set when I do.
Thanks

Talon, The original flexion is made to work with ninjaflex. The flexion HT may require tweaking but the barrels change out very easy if you need to swap back. The flexion HT comes with both barrels for the dual extruder set up.