Results 3,431 to 3,440 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
09-30-2016, 03:09 PM #3431
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-30-2016, 06:10 PM #3432
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-30-2016, 06:14 PM #3433
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-30-2016, 06:51 PM #3434
- Join Date
- Sep 2016
- Posts
- 80
Gawd, it's still going.
Can't wait to see what the final readout is. I'm fairly certain we're at probably 20 hours and we're at 80%.
-
09-30-2016, 06:55 PM #3435
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
09-30-2016, 08:34 PM #3436
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Problem on the QIDI X-ONE. I was doing a long print and I think the X stepper overheated. The gantry got stuck to one side and was real hard to move. turn the power off then back on and it moves freely but the motor was very hot.
How can I turn down the current to it if that is a good thing to try? It is a Marlin type board I believe. The scripts in S3D are very minimal due to it being a pre-release profile I am testing.
I remember some of you doing this on the Tech-1.
Maybe there is something else I should look at?
Thanks.
-
10-01-2016, 12:20 AM #3437
- Join Date
- Sep 2016
- Posts
- 80
I was printing one of these: http://www.thingiverse.com/thing:1065206
I went for maximum size on the Qidi. 25 Hours, 36 minutes. Looks pretty good, I'll get a picture tomorrow.
-
10-01-2016, 01:25 AM #3438
-
10-01-2016, 01:40 AM #3439Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
10-01-2016, 05:54 AM #3440
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion