For ABS I use the QIDI sticker with glue.
I got a tip on here that works for PLA as well.
Apply a layer of glue while cold. Then preheat the bed and one more layer hot then print.
Sticks well and comes off easy once cool.


Quote Originally Posted by Merijeek View Post
I have PLA nailed, but I have yet to do anything other than produce a tip-hugging blob when using ABS.

230 on extrusion, 110 on the bed. I am using painter's tape so that I can actually get my PLA stuff off the bed (it was HARD to get stuff off without it).

However, PLA simply will not adhere. Period. I've leveled the bed when the bed was at 110. Same leveling process I use with PLA.

There a trick I'm missing?

NOTE: I've had some luck with a gluestick, but the stuff I'm getting looks like craaaaaaaaaap. Like, missing lines all over the place on my first layer and such.