Results 1 to 10 of 25
Thread: Extruding Problem
Threaded View
-
09-26-2016, 04:28 AM #9
- Join Date
- Sep 2016
- Posts
- 11
Cheers guys
So far i have found the following:-
A nozzle clog
A tube clog
AND a gear clog ( fillament jammed in the motor cog)
I have cleared all these but am still getting the pulsing.
I have tried the filaments i have i know are good in both extruders but this left one still a no go.
Does anyone know if one of the screws behind the heat sink is a tensioner
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion