Results 1 to 10 of 396
Threaded View
-
09-24-2016, 10:08 AM #10
- Join Date
- Feb 2015
- Posts
- 371
What i have managed to find out is when the fans kick on the temp drops....and continues to drop. If I redirect the fans, the temp comes back up. This happens at all fan speeds.
I was using the new silicone sock but took it off cause it ripped on one of my failed prints. I am going to put on another one to see if that makes any difference. I did run a PID autotune with it on and the fans blowing. Should I run the PID with the fans off and sock off?
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion