Results 1 to 10 of 396
Threaded View
-
09-23-2016, 08:53 PM #10
- Join Date
- Feb 2015
- Posts
- 371
Man, not sure I should have opened this can of worms. It was working fine before.
I went to check the servo angles and now it won't home. I am getting the following error...
Error:MINTEMP triggered, system stopped! Heater_ID: 0
Error:Printer halted. kill() called!
10 minutes later and i can get it to home but now Octoprint won't connect!
Error: volume.init failedLast edited by tsteever; 09-23-2016 at 09:26 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion