Results 1 to 10 of 396
Hybrid View
-
09-23-2016, 10:22 AM #1
- Join Date
- Feb 2015
- Posts
- 371
I am getting some inconsistent results. I have had about 50% fail rate since updating to the new firmware.
I think I have tracked my problem down to the ABL probe. It seems to over extend which results in a crash. I readjusted the extend and retract angles. I tested these by running a g28 and then a g29 and it worked. I shut down the printer.
The next day I ran a print and it failed. Looks like the ABL probe is using the old values even though the firmware has been updated with new values.
Ideas on where to start?
-
09-23-2016, 11:24 AM #2
- Join Date
- Oct 2014
- Posts
- 134
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help