Results 1 to 10 of 25
Thread: Extruding Problem
Threaded View
-
09-22-2016, 07:20 PM #4
Yes, I did purchase 6 feet but unfortunately it seemed to be ~0.1mm oversized. It was so slight that I could jam it into the feed tube and I wasn't fond of that technique. I put the cut pieces aside for now and will post process them in the near future (rainy day project).
I didn't want to mess around with yanking a seized PTFE tube out with pliers and chose to pickup the ~$20 QIDI 4 nozzle + 4 ptfe tube kit on ebay. Three of the nozzles and tubes have been utilized in the past 1200 hours of printing and I was fortunate to have my first nozzle last to over 1000 hours.Last edited by cncartist; 09-22-2016 at 09:09 PM. Reason: grammar
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion