Why is my build plate z level getting messed up

[wirlybird]

Do you suggest to set them both to 0?

220 and 80 as an temperature of the extruder and HBP?

I might research the settings a bit. It seems one may be telling it to start the supports a little to high for the first layer.

I run my bed at 65 for the first couple layers then to 60 and that is with a glass bed. As for extruding I run from 190 to 210 or so.

[fontseeker]

I might research the settings a bit. It seems one may be telling it to start the supports a little to high for the first layer.

I run my bed at 65 for the first couple layers then to 60 and that is with a glass bed. As for extruding I run from 190 to 210 or so.

Going to try both values at 0 and a layer height of 0.1mm for the support structures to make it go a bit slower, might help. Will let you know how it goes.

As far as my temperatures, I have used 220C and 40C for the build plate and it has always gone fine.

Thanks for the help, will let you know how it turns out.