Thank you Roxy and clough42 for the quick response. I actually built an off board power supply to compensate for current draw. I am using a RUMBA board and it did not source enough power to run the servo. I really liked the servo headers and power jumper on a RAMPS board, so I built a daughter board for my RUMBA. I am picking up the PWM signal from pin 5. I pull 12v from main and regulate it to 5v on the sweet little daughter board where I have two servo headers plus three extra power pin sets. Pins 5 and 6 (PWM) get pulled into the daughter board and routed to the servo pin headers. I have been running a pi3 running octopi on one of the power sets so that I have WiFi control of the printer. I pulled the pi off the first time this happened because I figured (like clough42) that I was short juice. It didn't help. The servo isn't drawing current from the Board. The probe draws the same current whether it is on the swing arm or not. By the way clough42, it is your swing arm design. Thank you for that.

And as an aside, I print on borosilicate glass with PEI surface. I use the peel and stick PEI sheets.