Results 1 to 10 of 96
Thread: Anyone used Printbite surface ?
Threaded View
-
09-10-2016, 04:44 PM #11
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
This one is not by cncartist, but is an exceptionally useful hinge for the QiDi's front door. http://www.thingiverse.com/thing:1697406 If you slide it to the right it locks the door up in the open position, rotate down by 30 degrees and you can lift to remove the entire door. Kind of made the door clip unnecessary though.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help