If slow means better quality, then i can wait, days if i must. I have so far only few "print ready" models. I can also place it in a safe place where it can work day and night.

Ive seen quite a few prints and they all have that same problem, some "layers" are clearly visible while most are perfectly in check.

I've been printing with SLS via a partner but the cost is starting to pile up. There seems to be some air in the price, too much, so i'm hoping to do most goofy parts and simple testing myself. My final "goal" is to print myself an entire airsoft-gun, a legend from the 80s, the H&K G11K2. My estimate is that it would cost about 600-900 dollars while theres actually not much that could prevent me to do so on a "homebrewn" machine.
I've waited ten years to have that gun. I will gladly wait a few days to see it built perfectly.

How much does those "flexible" mats cost? Thus far ive only seen hard plastics and SLS printed material.