Results 1 to 3 of 3
-
08-27-2016, 04:34 PM #1
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
FFCP spool holders to big for MakerGeeks Filament
My makergeeks filament will not fit on the spool holders that came with the FFCP. The holder is to big for the hole in the spool.
Do you have a recommendation for a good alternative?
-
08-30-2016, 01:56 PM #2
- Join Date
- Feb 2015
- Posts
- 91
Huh, I hadn't noticed that since I switched away from the spool holders a long while back. I've got my active spools in a closed container with silica packets behind the printer.
You could try this guy: http://www.thingiverse.com/thing:996398
-
08-30-2016, 02:43 PM #3
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Yea, I do that on my other printer but this one is new so just using the holders for now.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion