Results 1 to 10 of 26
Threaded View
-
08-26-2016, 01:31 PM #5
The whole cantilever thing is given far too much attention. The bed is trammed to be parallel to the XY axis; it really doesn't matter if the arms aren't perpendicular to the rods. The prints themselves are very light and not enough to make make the bed droop.
That said I prefer the setup where the the extruder carriage does the X & Z movements and the bed the Y movement. I have seen this setup on many CNC machines and consider it to be the better option provided the bed runs on fix rods beneath the it.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion