Results 1 to 10 of 26
Threaded View
-
08-26-2016, 01:31 PM #5
The whole cantilever thing is given far too much attention. The bed is trammed to be parallel to the XY axis; it really doesn't matter if the arms aren't perpendicular to the rods. The prints themselves are very light and not enough to make make the bed droop.
That said I prefer the setup where the the extruder carriage does the X & Z movements and the bed the Y movement. I have seen this setup on many CNC machines and consider it to be the better option provided the bed runs on fix rods beneath the it.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion