Results 1 to 10 of 17
Thread: PETG Retraction tests etc
Threaded View
-
08-15-2016, 06:37 AM #2
okay you've got print speed at 40mm/s and movement speed at 150mm/s.
At what point does it get a chance to retract the petg before the carriage zooms off somewhere else.
Try dropping your carriage movement down to the same as your print speed.
gives everything a chance to work before the print head crosses gaps.
your firat layer height is 0.36 mm - why ?
And you're only extruding at 87%
Got to say those are some really weird settings. They seem to cancel each other out - so why change them in the first place.
Can't see any temperature settings.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion