Results 11 to 17 of 17
-
08-08-2016, 02:01 PM #11
Great paper, thank you for sharing it!
-
08-08-2016, 02:03 PM #12
Thanks for posting this. It's really interesting. Your findings are the opposite of what I've experienced which intrigues me. I need to examine my methods and see what might have led to that. I trust that your experiments are reliable and will enjoy looking through your data.
Bambu P1S/AMS
NVision4D http://nvision4d.com
-
08-08-2016, 02:54 PM #13
Fascinating, I've dowloaded it as pdf I'll stick it on my nook for later perusal :-)
Thanks !
-
08-08-2016, 07:16 PM #14
- Join Date
- Aug 2015
- Posts
- 256
In my experience prints become weaker once you exceed 50% of the nozzle diameter.
-
08-09-2016, 01:39 AM #15
- Join Date
- Sep 2014
- Location
- Brummen, Netherlands
- Posts
- 265
Really nice and high quality Master's thesis Frans, thank you so much for sharing it with us!
-
08-09-2016, 03:36 AM #16
Frans, Thank you! This is great work and very helpful to the 3D printing community.
Thinner layers make for stronger parts.
In my experience a 0.15mm layer height with a 0.4mm nozzle gives the best tradeoff in print quality vs speed.
Imagine a cross-section of a 3D printed wall. The extruded filament comes out round with the width of the nozzle, and is compressed to the set layer height.
This leaves air pockets in between layers. With a 2x thinner layer, because the nozzle size remains constant, you get half the material in half the height, which means the filament gets compressed twice as much leaving half the air pocket. Because the filament is forming more or less a flatter ellipse, the area where the layers meet will exponentially increase (at least more than linear). Also the part becomes more homogeneous overall making for a much stronger part.
This has consistently been my experience.
@Frans, for your experiments n = ?
-
08-10-2016, 03:09 PM #17
Thank you for the kind feedback!
@ralphzoontjens
I think that is a good theory! Not sure if it is enough to explain the phenomenon but still.
What n are you thinking of?
Moderator note: Late post is due to unexpected delay in obtaining moderator approvalLast edited by printbus; 09-17-2016 at 12:19 PM.
Printed Model of Motor Cooling Fan...
Yesterday, 02:07 PM in General 3D Printing Discussion