Results 1 to 10 of 19
Thread: Printer Enclosure Questions
Threaded View
-
08-07-2016, 10:31 AM #13
- Join Date
- Jul 2016
- Location
- Pennsylvania, USA
- Posts
- 255
Hi
I have always just run the printer in a very normal room and not worried about it. So far I have not dropped dead because of it I have never seen any data that shows normal filaments at normal temperatures are a health hazard. Some of the older (years ago) ABS formulations were a bit stinky, that's about it.
Bob
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help