Results 1 to 10 of 17
Thread: gcode for quieter printing
Threaded View
-
08-06-2016, 03:08 PM #10
- Join Date
- Dec 2014
- Location
- North Carolina
- Posts
- 23
I realize this thread has died but thought I should post this in the event that a Dreamer owner ends up here searching.
According to documentation from Flash Forge, the Dreamer does not use G130. It uses M907 to set the stepper currents.
I suspect that the original poster's success was the result of the Placebo effect.
It is, of course, possible that FF has changed the newer Dreamers but my 2 yo one definitely does not respond to a G130 ......
Graham
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion