Results 1 to 3 of 3
Thread: Clogged Extruder
Threaded View
-
08-02-2016, 03:15 PM #3
- Join Date
- Jun 2015
- Posts
- 2
I suggest printing out this anti-buckling backing plate for the extruder. Take apart the extruder and take pictures during every step so you don't forget how it goes back together. I used it on my Dremel (which is a repackaged FlashForge). Not only does it allow you to easily print flexible filament but it should also lessen filament jams.
Moderator note: Post is late to view due to unexpected delay in obtaining moderator approvalLast edited by printbus; 10-05-2016 at 06:57 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion