Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
08-02-2016, 12:01 PM #11
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
I have not noticed that but will check next time I change.
I am only using "load" to change filaments and has worked well. Advice I read somewhere on line said to clip the filament and then start the load process and follow the old filament in with the new and run it for a bit until it runs clear. So far it has worked fine.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion