Results 1 to 10 of 16
Threaded View
-
08-01-2016, 03:38 AM #2
- Join Date
- Jun 2015
- Location
- Sydney Australia
- Posts
- 36
I would do the following:
1) clean the nozzle if the filament is sticking to the nozzle
2) level the bed
3) do a physical measurement of the filament diameter, and compare it to the slicer measurement
Hope this helps
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help