Results 1 to 2 of 2
Thread: A Clean "wipe" after ABL
-
07-27-2016, 12:37 PM #1
- Join Date
- Jun 2016
- Posts
- 15
A Clean "wipe" after ABL
Hi All,
Curious, after my printer checks the 9 points of the bed using the Auto Bed leveling, There is a big "clump" of pla that has oozed out do to the heat of the hot end. normally it will come off during the two rounds of the perimeter lay down, but sometimes not. I have heard of people doing some kind of "wipe" close to one edge of the heat bed to clear this before printing. can this be done without adding a print object to the slicer? I just want it to be a one or two times pass.
If you're not sure what i mean, imagine wiping off the excess paint on a paint brush before painting the object. that's the best way I can describe it.
Thanks
-
07-27-2016, 04:19 PM #2
I believe the latest Marlin has a Nozzle Wipe command. If I remember correctly, it would be G27. (I had something at G27 and had to move it because Joao grabbed that location) You can ask over at: https://github.com/MarlinFirmware/Ma...3Aupdated-desc to get the specifics....
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion