Thank you for all of your suggestions (but a little late for me but not for others reading).. I decided in the end to go with the Tarantula as I don't mind Full DIY. The first response in this thread came after I had already received it from China so.... , I just got it fully up and running and did a test cube using CURA as the slicer and it turned out almost perfect.. The physicality was really good but the size was off not sure if it is due to shrinkage or flow rate but I will figure that out.. I really quite like it. I see a couple things that can be improved but generally speaking it is a pretty robust machine. I ended up getting the Large bed and metal extruder as well as the auto level.. but after building it the auto level maybe shouldn't have been bought.