Results 2,431 to 2,440 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
07-19-2016, 05:43 PM #2431
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-19-2016, 05:49 PM #2432
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-19-2016, 05:54 PM #2433
- Join Date
- Feb 2016
- Posts
- 360
-
07-19-2016, 05:58 PM #2434
- Join Date
- Feb 2016
- Posts
- 360
Dude....its plastic fumes, not mustard gas.
It going through a dual-filter exhaust system designed for things MUCH more harmful and noxious.
Any good maker know this simple fact:
There is what the label SAYS you can do, and what can ACTUALLY be done....and typically a huge margin between the 2.
Manufactures have to be overly careful when putting such labels on a product...less they be sued by morons.
Never take a lable at face value, as its probably WAY below what any given thing can actually handle.
-
07-19-2016, 06:02 PM #2435
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-19-2016, 06:54 PM #2436
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-19-2016, 11:01 PM #2437
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-20-2016, 05:44 AM #2438
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Yes, that was with the red crystal straight out of the package. I am going to run a decreasing temp test to see where the stringing stops. That is what I did for the PLA and finally found 190 to be good. My concern is if I am getting a good bond at that temp.
The other thing I am questioning is if the extraction settings are even working on the left extruder. I can turn things way up and see no change in the print.
-
07-20-2016, 09:19 AM #2439
- Join Date
- Feb 2016
- Posts
- 360
Been questioning the retraction settings myself.
When I was using the FlashForge profile in S3D the stringing was VERY minimal. Now with the Qidi profile the retraction values are exactly the same, but I see alot more strings, and phantom towers (travel towers).
I have done almost all my PLA prints at about 190c. I can assure you that layer bonding is just fine at that temp. Made a ring for my wife of PLA that has survived 4 months of her work (she a waitress). Also printed a plate-mail shoulder, and had my son smack it with a bat...it didnt even crack..granted he didnt hit so hard as i was wearing the piece at the time lol.
-
07-20-2016, 09:56 AM #2440
- Join Date
- Aug 2014
- Posts
- 627
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help