Results 1 to 1 of 1
-
07-19-2016, 09:39 PM #1
- Join Date
- Jul 2016
- Posts
- 1
New Printer - Ramps 1.4 w/ GADGETS3D display displaying mostly garbage
I have a Ramps 1.4 board w/1 extruder and a Gadgets 3d lcd display, I have tried swapping the cables.
I am using marlin firmware and uncommented out the gadgets3d line and changed the mainboard to the ramps 1.4
note: [] = square block, could not post a picture on this forum for some reason so this is what is displayed on the lcd
Line1: []/[]/[]?[]/[]/[]?[]?[]/[]/[]?
Line2: []--:--[]/[]?[][] /[]/
Line3:
Line4: Err: MAXTEMP
I would post an image but no matter how tiny I and low quality I make the image I cannot upload it to this forum, I click upload and nothing happens
any ideas?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion