Quote Originally Posted by wirlybird View Post
What extruder temp do you use for makergeeks PLA? I am trying 230 and 220 and not sure what I think yet.
Really depends on what your printing. I don't do much in PLA, but what I do has wide range, from 190c to about 228c.

If its something 'basic' is shape you can lower the heat some. If its something complex or with very high definition bit then you gonna wanna crank the heat up for the higher viscosity.
The only thing I use PLA for is very artistic or fine detail prints that just wont come out in ABS. Also the food safe stuff...but not by choice. If I could get FDA abs Id go that route.

I don't like pla....