Results 1 to 10 of 13
Threaded View
-
07-15-2016, 01:47 PM #9
- Join Date
- Jul 2016
- Posts
- 43
Doing a lot of tinkering I still cannot get it to print past a certain height.
I printed three pieces - all of which worked perfectly, then figured I had it worked out... printed the tall piece that has been plaguing me for quite some time and boom - failed again.
It is cutting a notch into my filament - could this be heat creep? I have felt my extruder motor and it feels fine, not hot at all.
I'm still just frustrated and lost.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion