Results 1 to 1 of 1
-
10-18-2013, 08:25 AM #1
Replicator 2X Dual Extrusion Problem
I know that Dual Extrusion is a bit picky at times, but we have yet to get a successful dual-print that looks good...
The most recent failure was when I took the pre-loaded chain model that comes with the printer SD chip and cut it up a bit so that every other link would print with a different color to the one next to it.
I can post a picture of it, but I know as a fact that the model will print with one extruder on our Replicator 2..
Here is what it I came back to the lab to find yesterday:
Close-Up.jpg
Full Problem.jpg
Yes, that blob of red is a solid chunk of plastic that the printer just spit out.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion