Results 1 to 10 of 757
Threaded View
-
07-10-2016, 12:22 PM #32
If I ignore pronterface, which forces all alpha characters to UC, and use a gcode file with the LC n will it work? i'm on 1.1 rc 6 bugfix now. is the P implemented in rc 6 or yet to be changed?
I would go ahead and just try it but I'm still wrestling with the allowable probed area of the bed vs probe offset vs homing at the right back thing.
[....later]
OK, reflashed back to old DACB fork and ran a test gcode file with "G29 n 2" and it worked, probed four points as expected. I'm going to stick with this until I get a better understand the new bed layout setup in RC bugfix. Thanks very much for the help and for your work as a Dev!Last edited by TopJimmyCooks; 07-10-2016 at 12:43 PM. Reason: added info
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help