Results 2,251 to 2,260 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
07-07-2016, 05:43 AM #2251
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-07-2016, 05:47 AM #2252
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-07-2016, 05:49 AM #2253
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-07-2016, 05:52 AM #2254
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-07-2016, 08:37 AM #2255
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-07-2016, 08:54 AM #2256
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
I don't think the distance part matters much, but anything binding does. I use PTFE tube that is 4mm id, my hope is there's less restrictions / binding. The quick connect fittings are also larger as that gives me more slop for alignment. My setup is not the poster child for short runs, and so far (knock on wood) no problems with the filament binding have surfaced. If you look for it, some people have rather extensive layouts/paths for their filament run. Mine pales compared to some I've seen pictured.
-
07-07-2016, 09:40 AM #2257
-
07-07-2016, 10:00 AM #2258
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-07-2016, 03:14 PM #2259
- Join Date
- May 2016
- Posts
- 55
Today I added binary STL export to my Lightwave STL export script. It's a bitch that I have to create 32-bit floats "by hand", but at least my STL file sizes are reduced by 70%. It's still probably faster, too, since before it had to convert the numbers to ASCII anyway.
Still loving the blue painter's tape. The best part is, if something screws up or gets stuck real good, I can just rip off the tape and lay down new tape without hesitation. I may go all out and buy those rolls of 6"-wide tape specifically for 3D printing.
-
07-07-2016, 04:33 PM #2260
- Join Date
- Aug 2014
- Posts
- 627
As I expected from Jetty and that is he is ignoring me and the issue with no PWM in his firmware.
If anyone else wants to try please do as I am curious why Marlin has it but not his firmware since both are based on the Arduino and hardware wise there really isn't much difference between a Mightyboard and a Ramps based board when you get to the heart of it. There was some talk of porting Marlin to Mightyboard but nothing happened.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion