Results 2,181 to 2,190 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
07-03-2016, 06:46 PM #2181
- Join Date
- Aug 2014
- Posts
- 627
-
07-03-2016, 06:49 PM #2182
- Join Date
- Aug 2014
- Posts
- 627
Now, what I would be very interested in is in compiling SF 7.7 and getting it uploaded. From what I read you can make your own profiles but I could care less if the stupid SF can't really do PWM or the Mightyboard that is in the Qidi. Either this is a hardware issue or a firmware issue and I suspect, more and more, it is a Firmware issue. If Matlin does it and SF is based off of Marlin then why not?
If anyone dares ask "the God" (unto himself) Jetty he may be able to shed some light on this but he and I are not on speaking terms.
-
07-03-2016, 07:37 PM #2183
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-03-2016, 07:44 PM #2184
- Join Date
- Aug 2014
- Posts
- 627
-
07-03-2016, 09:22 PM #2185
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-03-2016, 09:46 PM #2186
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
07-03-2016, 10:07 PM #2187
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-04-2016, 10:19 AM #2188
- Join Date
- May 2016
- Posts
- 55
-
07-04-2016, 10:23 AM #2189
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
Is anyone using this service? I read about it in a forum. Word was that S3D is not good at repairing/fixing the STL unlike Cura but that this site is good to use.
Also, any thoughts on Cura?
https://modelrepair.azurewebsites.net/
-
07-04-2016, 11:01 AM #2190
- Join Date
- Aug 2014
- Posts
- 627
That is just Netfabb basic as Microsoft took it over (or licensed it) a couple of, to a few years, ago and it normally can fix most stuff. Autodesk owns Netfabb now.
Never understood all of these one companies owning everything. Make something cool and some company will buy it out.
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion