Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
06-23-2016, 11:23 AM #11
- Join Date
- Aug 2014
- Posts
- 627
You know a lot of people forget about the PTFE tube because on a MK10 that sucker runs all the way to the bottom unlike a MK8 style. Even after the few prints I did there was colored PLA inside the bottom section of that tube which is the section in the nozzle.
One of the main reasons I despise a MK10 setup is because of that tube and how it runs all the way, the other is how bloody expensive a plain ole brass nozzle is for it compared to a MK8. 1 dollar, or less, MK8 is 7 to 20 dollars in a MK10 and there seems to be a much greater gamut of orifice sizes in a MK8 as well versus .4 on a MK10.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion