Results 1 to 10 of 30
Threaded View
-
06-22-2016, 04:52 PM #29
- Join Date
- Nov 2014
- Location
- Brevard, NC
- Posts
- 182
I tried just changing the stepper drivers to start with. When that failed, I changed all the whole arduino Mega+Ramps. I am at a loss as to what this problem is now. The print stopped about 40 minutes on this last print. I have replaced all the electronics & still have the same problem. I also replaced the P/S with the same Mean Well NES-350-12v. I have checked all the wires & connections, but maybe I have a bad connection somewhere that I missed. I am also using the Marlin RCBugFix firmware.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help