Results 1 to 2 of 2
Thread: top of model not closing up
-
03-11-2014, 11:57 AM #1
- Join Date
- Mar 2014
- Posts
- 3
top of model not closing up
Hi, do any of you have any ideas on why this model is not closing for me? I have run it 4 times with different filament diameter settings as well as different infill settings but no luck.
It is the squirrel model onthingiverse http://www.thingiverse.com/thing:11705
and the top of his head always endsup with a hole in it
-
03-11-2014, 04:34 PM #2
- Join Date
- Jan 2014
- Posts
- 462
I can see holes in the back lower down as well. Either you are under-extruding or your bridging is not the best. First step is to follow the calibration guide on the reprap wiki - especially section 3.9. This will help you with your bridging. If you're still experiencing problems after calibration, try increasing your infill further.
Printer will print perfect...
Yesterday, 10:44 AM in Tips, Tricks and Tech Help