Results 1 to 10 of 11
Threaded View
-
06-08-2016, 04:22 AM #9
We don't doubt that this is all true. We have ourselves been trying to get information from Omnidynamics but to no avail.
I would however be careful about the provenance of this post, it seems like an awful lot of research and time went into this which could suggest a conflict of interest by the poster. But Like we said there is something not quite right with the current state of this company. We to have seen working models, it is a shame that it does not appear to have manifested itself into a product.
@LambdaFF you will have joined the illustrious line of crowd funding backers that back a product that does not get launched, look at peachy printers and the like. I hope you did not put too much money into it.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help