Results 1 to 10 of 17
Threaded View
-
06-01-2016, 03:23 PM #11
This is a common issue. And we need to clean up how this is configured. (But that won't happen until after the Release Candidate goes Golden.)
It is being caused by a mis-understanding on your part how to configure the Z-Probe. The firmware doesn't know to be watching where ever you have the probe plugged in.
Do you have a Z-Min endstop? If so this complicates things (but it still can be configured). If you are just using the Z-Probe then the easiest way to get running is to enable:
Code:#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion