Results 1 to 10 of 17
Threaded View
-
05-28-2016, 04:44 PM #13
- Join Date
- Apr 2016
- Posts
- 30
I finally got it working. Black wire from probe goes to the first pin on the plug. Now, i need to find out how to disable the probe after leveling...... Other wise, the print will not start at the desired height.
Perhaps Roxy you could assist with that?
Decided to just adjust the sensor to where zero is right where the print height starts.Last edited by Roxy; 06-01-2016 at 03:17 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion