Qidi Tech 1 - Replicator 1 clone

[DarkAlchemist]

Thanks for clarifying, it's sometimes tough to know where references come from.

I do a lot of Google searches.

Typical in case humidity during ABS print for me is 36-42%.
I live in south Texas, right on the coast. Can literally walk to gulf of mexico from my house in about 3min.
I have a plan to deal with it, but it's kinda an expensive plan, so its little bit at a time ya.

I live near the Mississippi river and in the sumertime the humidity in the house is 70-80% and in the winter time 15-20%. Running a dehumidifier is loud and expensive (especially with these kinds of RH levels). My filament I stuck in a 20 dollar weatherproof container (it is not hermetically sealed though) and two Evadrys in it to keep the RH below 25%. When the RH goes to 27% I recharge the evadrys for 12 hours. Normally I get 5-8 weeks before the RH gets back to 27%