Results 1 to 10 of 48
Thread: I need two tiny gears
Threaded View
-
05-11-2016, 08:41 AM #39
okay looked at pic again, looks like 7mm between shafts.
I will now try that out with a couple of pins and some cardboard :-)
bugger won't let me upload video files directly.
Ah ha avi to gif convertor.
Let's try this:
weird, forum turned it into a jpg.
Alright let's try this:
That's somewhere between 7 and 7.4 mm between centres.
The new gears have tiny hole in centre.
The only issue was when the small gear rode up the pin and wasn't lined up. when they're both on the same level. they mesh really well.
These are 1mm thick as well.
Better video clip
http://slinging.org/forum/yabbfiles/.../minigears.avi
That little gif is kind of addictive lolLast edited by curious aardvark; 05-11-2016 at 09:55 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help