Results 1 to 10 of 11
Threaded View
-
05-11-2016, 06:55 AM #10
So the difference in your models may be due to the calibration of your xyz axis being out slightly. The printer is moving the steppers X number of steps per mm but the value of X may be too low, it has to move more steps to make up a mm.
try printing out a calibration cube to check and re-define your printers steps per mm. The instructions on the calibration calculations are also on the page.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion