Results 1 to 10 of 48
Thread: I need two tiny gears
Threaded View
-
05-10-2016, 01:50 PM #37
- Join Date
- May 2016
- Location
- Michigan
- Posts
- 22
Loving the gears! Looks great! I hope I am not pushing it by asking this question. Would you happen to have this same material in green? Don't get me wrong, blue looks GREAT! But the gears might show a tiny bit below my green platform/base. This way it would blend in a little bit better than blue.
If not, no big deal. I thought it would not hurt to ask. I plan to cover as much as I can with the base. So the gears might not show at all. I am not sure at this time, due to I have not gone that far yet. I wanted to make sure I can get this to work first. Then tackle that next. Just thinking ahead here a little bit.
Thanks,
Tony
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion