Results 1 to 10 of 10
Thread: Identifying PLA vs ABS Filament
Threaded View
-
05-07-2016, 08:31 PM #6
- Join Date
- Apr 2016
- Posts
- 6
While PLA does tend to be a little more brittle then ABS, good quality PLA shouldn't break that easily. Check out this video where you can see that's it not all that easy to break a couple strands of PLA filament
If a spool is open for a while the end might get a little brittle, so just cut off a foot or two and it should be fine. If it still breaks easily, it's probably low quality filament.Last edited by FilamentGuy; 05-07-2016 at 08:32 PM. Reason: grammar/spelling
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help